HI1-0390-2

HI1-0390-2 Overview

Shipping overseas is convenient due to the electrical component's packing in CDIP. High reliability is provided by advanced packaging method Bulk. In total, there are 16 terminations. High-quality output is provided by the electronic component's 1 channels. If the voltage supply is 15V volts, the electrical component should be turned on and run. 16 pins are injected to the electronic part body. The internal resistance of this digital multiplexer is 50Ohm. Please refer to the datasheets for 16 pins functions. There is Multiplexer or Switches analog multiplexer like this in the world. In normalcircumstances, users should not exceed 34V volts for the multiplexer. A cost-effective Dual, Single supply type analogue multiplexer. The lowest voltage fed to the electronic component should be 5V. For this multiplexer to operate, 90nA current would be sufficient. A voltage higher than 500μA may cause damage to the switch multiplexer. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 20V. For dual power supplies, a voltage of at least 5V should be attached. In this switch multiplexer, there are SEPARATE OUTPUT outputs available. The electrical part can be operated at 28V voltage levels. Among the inputs that can be operated are the 4 inputs. In an environment with a temperature higher than 125°C, the digital switches should not operate. 2-bits are supported.

HI1-0390-2 Features

1 Channels
90nA Supply Current
2-Bit

HI1-0390-2 Applications

There are a lot of Intersil (Renesas Electronics America) HI1-0390-2 Analog Switches & Multiplexers ICs applications.

• PDH Multiplexers
• ADCs such as AD7840/8, AD7870/1/2/4/5/6/8
• Fault Tolerant Systems
• Audio/video switches
• Channel Banks
• Cell phones
• 65 V DACs
• Battery Powered Systems
• ATM
• PDAs